Control unit installation guide

GUIDE

INSTALLATION OF THE CONTROL UNIT

1. Disconnect the battery and remove the screws in the underside of the seat.

2. Disconnect the control unit and remove the screws and cables on the control unit.

3. Unscrew the 4 screws on the frame of the original control unit

4. Replace the original control unit with the new one.

5. Replace the cables and screws on the control unit (on some models it is necessary to use plastic ties)

6. Connect the cable in the box to the new control unit, making sure that the side with the outer cable is opposite the control unit. Connect the other side of the cable to the smaller unit in the box at the inlet marked KZQ.

7. Connect the cable that was connected to the original control unit to the smaller to the smaller control unit in the package at the input marked CAR.

8. You can now connect the battery and drive your scooter.

SOFTWARE

1) extract the software

2) Disconnect the battery and connect the USB cable from the control unit to the computer.

3) open the software and click on connect 

4)click on the icon in the top right corner representing the person to set the software in English

5) change the parameters you need and click on download to save.
To load the recommended configuration, click on import, select the file in the archive downloaded from our site and select download to save.

DRIVER

Click HERE to download Drivers for Windows

SOFTWARE

For MQi+, M+, UQiGT HERE

CONFIGURATION

For MQi+Sport, M+ Sport and UQiGT Extended click HERE

For UQiGT Standard click HERE

CONFIGURATION

For MQi+Lite and M+ Lite click HERE

 

Software + Configuration

- NQi Sport, NQi Lite, NSport, NLite, N1S HERE

- M1, MPro, MSport HERE

- UQiPro / UPro HERE